Index for Section 1

Alphabetical listing for U

Bottom of page

UD(1)
NAME
  ud - interactive LDAP Directory Server query program

SYNOPSIS
  ud [-Dv] [-s server] [-d debug-mask] [-l ldap-debug-mask] [-f file]

DESCRIPTION
  ud is used to interogate a directory server via the Lightweight Directory
  Access Protocol (LDAP).

OPTIONS
  -s server Used to specify the name of an LDAP server to which ud should
	    connect.  If this flag is omitted, the value specified in the ud
	    configuration file is used.	 If no value is specified in the
	    configuration file, or the configuration file does not exist, the
	    name ldap is used.	Of course, it is up to the system
	    administrator to make sure that the name ldap can be resolved
	    (presumably through the use of a CNAME or A record in the DNS and
	    the appropriate search path specified in the resolver config
	    file).

  -d debug-mask
	    Sets the ud debug mask to the value specified. Values for the
	    mask can be dumped by using the -D flag.

  -f file   Sets the configuration file to the name specified.

  -l ldap-debug-mask
	    Sets the LDAP debug mask to the value specified.

  -v	    Turns on verbose output.  Also toggable via the ud verbose
	    command.

  -D	    Prints out a list of valid ud debug masks.

FILES
  /usr/internet/openldap/etc/ud.conf		  The ud configuration file.

SEE ALSO
  ud.conf(5), ldap.conf(5), ldap(3)

DIAGNOSTICS
  ud will try to be nice about error conditions, and in most cases prints a
  warm and fuzzy error message when it encounters a problem.  Sometimes the
  error will be unexpected, and in these cases, ud uses the ldap_perror()
  routine to print an informative diagnostic.

BUGS
  Too numerous to mention.

AUTHOR
  Bryan Beecher, University of Michigan

ACKNOWLEDGEMENTS
	OpenLDAP is developed and maintained by The OpenLDAP Project
  (http://www.openldap.org/).	     OpenLDAP is derived from University of
  Michigan LDAP 3.3 Release.

Index for Section 1

Alphabetical listing for U

Top of page